EASY MENU
EASY MENU
From the EASY MENU, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control. Then perform it according
to the following table.
Item Description
ASPECT
Using the ◄/► buttons switches the mode for aspect ratio.
See the ASPECT item in IMAGE
menu
(
34).
AUTO
KEYSTONE
Using the ► button executes the auto keystone function.
See the AUTO KEYSTONE item in SETUP menu
(
40).
KEYSTONE
Using the ◄/► buttons corrects the vertical keystone distortion.
See the
KEYSTONE item in SETUP menu
(
40).
KEYSTONE
Using the ◄/► buttons corrects the horizontal keystone distortion.
See the
KEYSTONE item in SETUP menu
(
41).
PICTURE MODE
Using the ◄/► buttons switches the picture mode.
The picture modes are combinations of GAMMA and COLOR
TEMP settings. Choose a suitable mode according to the projected
source.
NORMAL
ó
CINEMA
ó
DYNAMIC
ó
BOARD(BLACK)
DAYTIME
ó
WHITEBOARD
ó
BOARD(GREEN)
COLOR TEMP GAMMA
NORMAL 2 MID 1 DEFAULT
CINEMA 3 LOW 2 DEFAULT
DYNAMIC 1 HIGH 3 DEFAULT
BOARD(BLACK) 4 Hi-BRIGHT-1 4 DEFAULT
BOARD(GREEN) 5 Hi-BRIGHT-2 4 DEFAULT
WHITEBOARD 2 MID 5 DEFAULT
DAYTIME 6 Hi-BRIGHT-3 6 DEFAULT
• When the combination of GAMMA and COLOR TEMP differs
from pre-assigned modes above, the display on the menu for the
PICTURE MODE is “CUSTOM”. Please refer to the GAMMA and
COLOR TEMP (
31, 32) items in PICTURE menu.
•
When this function is performed, lines or other distiortions may appear.
(continued on next page)
To Next Page
Loading...
