To start the MENU, press the MENU button. The MENU
you last used (EASY or ADVANCED) will appear. EASY
MENU has priority to appear just after powered on. To
nish the MENU, press the MENU button again.
If you want to change it to EASY/ADVANCED MENU,
select the EASY/ADVANCED MENU on the menu.
Using the menu function
●
If you want to move the menu position, use the
▲/▼/◄/►
buttons after pressing
the POSITION button.
● Some functions cannot be performed when a certain input port is selected, or
when a certain input signal is displayed.
●
When you want to reset the operation, press the RESET button on the remote control
during the operation. Note that items whose functions are performed simultaneously with
operation (ex. LANGUAGE, H PHASE etc.) cannot be reset.
●
Even if you do not do anything, the dialog will automatically disappear after about 30 seconds.
This projector has the following menus: PICTURE, IMAGE, INPUT, SETUP, SCREEN, OPTION,
NETWORK, SECURITY and EASY MENU. The EASY MENU consists of functions often used, and
the other menus are classied into each purpose and brought together as the ADVANCED MENU.
Each of these menus is operated using the same methods with the ▲/▼/◄/►, ENTER and RESET
buttons. The buttons of the same name on the remote control and on the projector function equally.
Indication in OSD (On Screen Display)
RESET button
ENTER button
MENU button
Cursor buttons
The meanings of the general words on the OSD are as follows.
Start / nish the menu
NOTE
Indication Meaning
EXIT
Selecting this word nishes the OSD menu. It's the same as pressing the
MENU button.
RETURN Selecting this word returns the menu to the previous menu.
CANCEL or NO
Selecting this word cancels the operation in the present menu and
returns to the previous menu.
OK or YES
Selecting this word executes the prepared function or shifts the menu to
the next menu.
To Next Page
Loading...
