SECURITY menu
Item Description
MY TEXT
DISPLAY
1 Use the ▲/▼ buttons on the SECURITY menu to
select the MY TEXT DISPLAY menu and press the
► button to display the MY TEXT DISPLAY on/off
menu.
2 Use the ▲/▼ buttons on the MY TEXT DISPLAY
on/off menu to select on or off.
ON
ó
OFF
When it is set ON, the MY TEXT will be displayed
on the START UP screen and the INPUT-
INFORMATION- when the INFORMATION on the
SERVICE menu is chosen.
• This function is available only when the MY TEXT
PASSWORD function is set to the OFF.
MY TEXT
WRITING
1 Use the ▲/▼ buttons on the SECURITY menu to
select the MY TEXT WRITING menu and press
the ► button. The MY TEXT WRITING dialog will
be displayed.
2
The current MY TEXT will be displayed on the rst 3
lines. If not yet written, the lines will be blank.
Use the
▲/▼/◄/►
buttons and the ENTER or VIDEO button to select and enter
characters. The RESET button can be used to erase 1 character at a time. Also if
you move the cursor to DELETE or ALL CLEAR on screen and push the ENTER
or VIDEO button, 1 character or all characters will be erased. The MY TEXT can
be input up to 24 characters on each line.
3 To change an already inserted character,
press the ▲/▼ button to move the
cursor to one of the rst 3 lines, and use
the ◄/► buttons to move the cursor on
the character to be changed.
After pressing the ENTER or VIDEO
button, the character is selected.
Then, follow the same procedure as
described at the item 2 above.
4 To nish entering text, move the cursor
to the OK on screen and press the
ENTER or VIDEO button. To revert
to the previous MY TEXT without
saving changes, move the cursor to
the CANCEL on screen and press the
ENTER or VIDEO button.
•
The MY TEXT WRITING function
is available only when the MY TEXT
PASSWORD function is set to OFF.
To Next Page
Loading...
