EasyManua.ls Logo

Hitachi CP-SX635 - Internal Clock Battery

Hitachi CP-SX635
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
ENGLISH
1.
Turn the projector off, and unplug the power cord. Allow the
projector to cool sufciently.
2.
After making sure that the projector has cooled adequately, slowly
turn over the projector, so that the bottom is facing.
3.
Turn the battery cover fully in the direction indicated “
OPEN
using a coin or the like, and pick the cover up to remove it.
4.
One of two kinds of clock battery holder, A or B shown to the
right, is inside the battery cover.
For A holder:
Pry up the battery using a athead screwdriver or the like to take it out.
While prying it up, put a nger lightly on the battery since it may pop out
of the holder.
For B holder:
Press the metal claw of the battery holder putting a nger lightly
on the battery since it may pop out of the holder. Then the battery
will come up. Remove the battery.
5.
Replace the battery with a newHITACHI MAXELLL, Part No.
CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it into the
holder until it clicks.
6.
Replace the battery cover in place, then turn it in the direction
indicated “
CLOSE
” using such as coins, to x.
Internal clock battery
Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it has
stopped, please replace the battery according to the following procedures.
Battery Cover
WARNING
Always handle the batteries with care and use them only as directed. Battery may explode if
mistreated. Do not recharge, disassemble or dispose of in re.
And also improper use may result in cracking or leakage, which could result in re, injury and/or
pollution of the surrounding environment.
• Be sure to use only the batteries specied.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
Keep a battery away from children and pets. If swallowed consult a physician immediately for
emergency treatment.
Do not short circuit or solder a battery.
• Do not allow a battery in a re or water. Keep batteries in a dark, cool and dry place.
If you observe battery leakage, wipe out the leakage and then replace a battery. If the leakage
adheres to your body or clothes, rinse well with water immediately.
Obey the local laws on disposing the battery.
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
90°
OPEN
CLOSE
90°
NOTE
If the battery is inserted upside down in the B holder, it might be difcult to remove. If that happens, take
following measures:
(1)
Remove the battery cover and turn the projector's upside up.
(2)
While lifting the side of the projector closer to the lens, press the metal claw of the battery holder.
The battery will fall out of the holder, so be careful not to lose it.

Other manuals for Hitachi CP-SX635

Related product manuals