Hitachi CP-SX635 - Displaying the Picture; Turning off the Power

7
ENGLISH
BLANK LASER
ASPECT
PUSH
ENTER
PAGE UP
LASER
INDICATOR
MY SOURCE/
DOC.CAMERA
SEARCH
STANDBY/ON VIDEO RGB
PAGE DOWN
ESC MENU RESET
POSITION AUTO
MAGNIFY
ON
OFF
MY BUTTON
1
2
VOLUME
+
-
FREEZE KEYSTONE MUTE
BLANK LASER
ASPECT
PUSH
ENTER
PAGE UP
LASER
INDICATOR
MY SOURCE/
DOC.CAMERA
SEARCH
STANDBY/ON VIDEO RGB
PAGE DOWN
ESC MENU RESET
POSITION AUTO
MAGNIFY
ON
OFF
MY BUTTON
1
2
VOLUME
+
-
FREEZE KEYSTONE MUTE
Displaying the picture
1.
Make sure that the signal source is sending the signal to the
projector.
2.
Use the
VOLUME +/-
buttons to adjust the volume. To have
the projector silent, press the
MUTE
button on the remote
control.
3.
Press the
INPUT
button on the projector.
Each time you press the button, the projector switches its input
port in turn.
4.
Press the
ASPECT
button on the remote control. Each time
you press the button, the projector switches the mode for
aspect ratio in turn.
5.
Use the zoom ring to adjust the screen size.
6.
Use the focus ring to focus the picture.
7.
Use the vertical lens shift dial to shift the picture upward or
downward. It is recommended to adjust the picture upward.
8.
Use the horizontal lens shift dial to shift the picture left or
right.
ASPECT
button
INPUT
button
Focus ringZoom ring
Top
2/5
1/10
1/10
Turning off the power
1.
Press the
STANDBY/ON
button on the projector or the remote
control.
The message “
Power off?
” will appear on the screen for about
5 seconds.
2.
Press the
STANDBY/ON
button on the projector or the remote
control again while the message appears.
The projector lamp will go off, and the
POWER
indicator will
begin blinking in orange.
Then the
POWER
indicator will stop blinking and light in
steady orange when the lamp cooling is complete.
3.
Make sure that the
POWER
indicator lights in steady orange,
and set the power switch to the OFF position (marked “
O
”).
The
POWER
indicator will go off. Attach the lens cover.
Do not turn the projector on for 10 minutes or more after turning it off. Turning the projector on
again too soon could shorten the lifetime of some consumable parts of the projector.
STANDBY/ON
button
POWER
indicator
Power
switch
WARNING
►
Do not touch around the lamp cover and the exhaust vents during use or just after use,
since it is too hot.
MUTE
button
VOLUME +
/
-
buttons
Lens shift cover