Putting batteries
Please load the batteries before using the remote control.
1.
Slide back and remove the battery cover.
2.
Put the two AA batteries (
HITACHI MAXELL, Part No.LR6 or R6P
)
into the holder, according to the polarity markings (
+
) and (
-
) on the holder.
3.
Put the battery cover back to its former state.
Remote control (continued)
WARNING
►Always handle the batteries with care and use them only as directed. Improper use
may result in battery explosion, cracking or leakage, which could result in re, injury
and/or pollution of the surrounding environment.
• Be sure to use only the batteries specied. Do not use batteries of different types at the
same time. Do not mix a new battery with used one.
• Make sure the plus and minus terminals are correctly aligned when loading a battery.
• Keep a battery away from children and pets.
• Do not recharge, short circuit, solder or disassemble a battery.
• Do not place a battery in a re or water. Keep batteries in a dark, cool and dry place.
• If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
• Obey the local laws on disposing the battery.
Buttons
(1)
STANDBY/ON
button
(2)
VIDEO
button (3)
RGB
button
(4)
MY SOURCE/DOC.CAMERA
button
(5)
SEARCH
button (6)
BLANK
button
(7)
LASER
button (8)
ASPECT
button
(9) Lever switch : acting 3 functions as below.
Cursor button ▲ : to slide toward the side marked ▲.
Cursor button ▼ : to slide toward the side marked ▼.
ENTER
button : to push down the center point.
(10) Cursor button ◄ (11) Cursor button ►
(12)
PAGE UP
button (13)
PAGE DOWN
button
(14)
ESC
button (15)
MENU
button
(16)
RESET
button (17)
POSITION
button
(18)
AUTO
button
(19)
MAGNIFY ON
/
OFF
button
(20)
MY BUTTON 1
button (21)
MY BUTTON 2
button
(22)
VOLUME +
/
-
button (23)
FREEZE
button
(24)
KEYSTONE
button (25)
MUTE
button
To Next Page
Loading...
