Connecting power supply
1.
Connect the connector of the power cord to the
AC IN
(AC
inlet) of the projector.
2.
Firmly plug the power cor
d
's plug into the outlet.
AC IN
to the outlet
Connector of the
power cord
Turning on the power
1.
Make sure that the power cord is rmly and correctly connected
to the projector and the outlet.
2.
Remove the lens cover, and set the power switch to the ON
position (marked “
I
”).
The
POWER
indicator will light up in steady orange. Then
wait several seconds because the buttons may not function for
these several seconds.
3.
Press the
STANDBY/ON
button on the projector or the remote
control.
The projection lamp will light up and the
POWER
indicator will
begin blinking in green. When the power is completely on, the
indicator will stop blinking and light in steady green.
STANDBY/ON
button
POWER
indicator
NOTE
• When the
AUTO ON
in the
OPTION
menu is set to the
TURN ON
, and the power was turned
off by the power switch last time, turning the power switch on makes the projection lamp light
on without pushing the
STANDBY/ON
button. For more information, please see the “
Operating
Guide
” in the CD.
Power
switch
WARNING
►A strong light is emitted when the projector’s power is on. Do not look into the lens
of the projector or look inside of the projector through any of the projector’s openings.
WARNING
►Please use extra caution when connecting the power cord, as incorrect or faulty
connections may result in re and/or electrical shock.
• Only use the power cord that came with the projector. If it is damaged, consult your
dealer to get a new one.
• Only plug the power cord into an outlet whose voltage is matched to the power cord.
The power outlet should be close to the projector and easily accessible. Remove the
power cord for complete separation.
• Never modify the power cord.
To Next Page
Loading...
