Regulatory notices
About Electro-Magnetic Interference
In Canada
This Class A digital apparatus complies with Canadian ICES-003.
In the US and places where the FCC regulations are applicabl
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to case harmful interference in which case the user will be required to correct the
interference at his own expense.
INSTRUCTIONS TO USERS:
Some cables have to be used with the core set. Use
the accessory cable or a designated type cable for the connection. For cables that have a
core only at one end, connect the core to the projector.
CAUTION:
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
To Next Page
Loading...
