48
CP-WX11000 ( P6WX )
6-16 Reset of the Network Web password / User ID, Network Control password
ATTENTION : Performing this operation initialises the network settings. If the projector has
the customised settings in the network, make a note of the network settings to restore
them before this operation.
1. Display the SETUP in the NETWORK menu.
2. Select “TURN OFF” in the item of
DHCP.
3. Enter “255.255.255.255” in the item of
IP ADDRESS.
4. Enter “255.255.255.255” in the item of
SUBNET MASK.
5. Enter “255.255.255.255” in the item of
DEFAULT GATEWAY.
6. While NETWORK menu is displayed, press the RESET button of the remote control.
7. Press Ÿ button to execute reset.
The operation described above resets not only Web password but also NETWORK settings.
NOTE:
When you execute this reset operation with any other settings than above (described in the
step 2 to 5), the WEB password, SNTP server address, DATE AND TIME and other sched-
ule settings are not initialised but the network settings (DHCP, IP ADDRESS, SUBNET
MASK and DEFAULT GATEWAY) are initialised.
8. If the network settings had been customised, restore them by manual operation.
Press RESET button
To Next Page
Loading...
