63
CP-WX11000 ( P6WX )
3. Assembling and Disassembling the power unit block.
a. Assembling and Disassembling the ballast.
ATTENTION
Note the Heatsinks have the Sharp edge, at the time you connect/disconnect CNPFC.
Assembly
Disassembly
Confirm that ballast is locked by
locking spacer completely.
CNPFC
Release purse lock before you disconnect CNPFC.
A
B
C
Never loosens A, B or C.
Assemble in following procedure if
you have loosened screws A, B or C.
(1) Tighten screw A firmly.
(2) Tighten screws B and C lightly.
(3) Attach ballast board with 3 screws firmly.
(4) Tighten screws B and C firmly.
Make sure that three pairs
of screws (six screws) are
tightened firmly.
Make sure that black
sheet is not pinched
after you tighten screws.
WARNING
These operations are very important on
product safety. Follow the instructions
in assembling/disassembling.
To Next Page
Loading...
