62
CP-WX11000 ( P6WX )
When assembling
a. Tighten 2 screws on upper case, 2 screws on front, 4 screws on back, 4 screws on left
side and 2 screws on right side to detach upper case.
(Refer disassembling procedure.)
b. Attach front cover and front ring.
Attach front cover to projector. Then attach front ring with turning right.
2. Attaching and Detaching the MAIN board.
Remove these screws to detach the MAIN board.
CAUTION
Detach the lamp door before you
detach the MAIN board.
1 Screw
CAUTION
When you disconnect cables from
connector E310, E331, E902, ES01,
ES02 and ES11, unlock the hook so
that you may not damage it.
1 Screw 1 Screw
Never remove there 3 screws when you detach the MAIN board.
1 Screw
1 Screw
1 Screw
5 Screws
E331
E902
ES01
ES02
ES11
E303
To Next Page
Loading...
