50
CP-X2511N(C15I-25N2) / CP-X3011N(C15I-30N2) / CP-X4011N(C15I-40N2) / CP-X2011N(C15-20N2) / ED-X45N(C15-20N2)
Notice
■ Detach and attach the upper case.
Follow the procedure below to detach and attach the upper case.
When disassembling
CAUTION
The lamp door must be removed before the upper case when disassembling the machine. If the upper
case is detached with the lamp door installed, the MAIN board might be damaged.
a. Remove the Lamp door.
Loosen this screw
b. Remove 8 screws on the bottom and 2 screws on the rear to detach the upper case.
CAUTION
This is not a screw hole. Do NOT insert a screw or screwdriver into it to avoid damaging the inside.
8 screws
Lamp door
2 screws
To Next Page
Loading...
