Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)10-04-40]
Rev.1.1
INST(RM)10-04-40
5. Removing LAN cables
(1) Disconnect the LAN cable from the LAN Board 1 (Management LAN port) in Controller Board
x1.
(2) Remove the LAN cable disconnected in Step (1) from Lx-DKCx on the LAN cable kit for relay
connection to SSVP0.
(3) Disconnect the LAN cable from the LAN Board 2 (Management LAN port) in Controller Board
x2. (This step is not required when SSVP1 is not installed.)
(4) Remove the LAN cable disconnected in Step (3) from Lx-DKCx on the LAN cable kit for relay
connection to SSVP1. (This step is not required when SSVP1 is not installed.)
(5) Remove the LAN cables from LAN ports Lx on the front sides of HSNBXs while checking the
labels attached to the LAN cables.
In the case that all of DKC-2, DKC-3, DKC-4, and DKC-5 are removed, perform Step (6).
(6) Pull out the LAN cable kits for relay connection from the rear sides of HSNBXs.
Figure 10-4 Removing LAN cables
DKC-3
DKC-2
DKC-1
DKC-0
L0L1L2L3
L0L1L2L3
L0-DKC2
L1-DKC3
L2-DKC4
L3-DKC5
L0-DKC2
L1-DKC3
L2-DKC4
L3-DKC5
LAN cable kit
(SSVP0, L0-L3)
rear view
LAN cable kit
(SSVP0, L0-L3)
HSNBX-1
HSNBX-0
LAN cable
LAN cable
LAN board 1 (Management LAN port) LAN board 2 (Management LAN port)
HSNBX-1 front side
(SSVP1)
HSNBX-0 front side
(SSVP0)
To Next Page
Loading...
