Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)10-04-80]
Rev.1.1
INST(RM)10-04-80
(2) For the rail type with a stopper, go to Step (3).
For the rail type without a stopper, remove the stopper (R), the stopper (L), and the binding screws
(two for each stopper) fixing them from the rear side of the rack.
Go to Step (3).
Figure 10-7 Removing Stoppers
(3) Remove the Controller Chassis from the rack frame referring to mounting procedure using the
special lifter. (see “Mounting Storage System on a Special Lifter” (INST(IN)06-01-10)
)
9. Reinstalling the removed parts
Install the Controller Boards, components, and power supplies to the removed Controller Chassis (see
“Installing Components” (INST(IN)08-01-10).)
If they are already installed, this step is not necessary.
Stopper (L)
Rear side of rack
Stopper (R)
Binding
screw
Stopper (L) Stopper (R)
Binding screw
Binding
screw
Binding screw
To Next Page
Loading...
