Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)11-04-90]
(a) Loosen two screws (blue) fixing the Channel Board to be removed.
(b) Hold the screws (blue) and pull out and remove the Channel Board.
(c) Insert the dummy into the slot to the end from which the Channel Board (CHB) has been
removed.
Figure 11-7 Removing the Channel Board
Channel Board
Screw (blue)
DKC
Shield Finger
Dummy
(d) Remove the other Channel Boards in the same way.
Rev.2
INST(RM)11-04-90
To Next Page
Loading...
