Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)11-04-100]
(2) Removing the Disk Board
NOTICE: When removing the Disk Board, hold it with both hands and remove it straight not to
apply a shock to with any components.
Disk Board
Main edge connector
(a) Loosen two screws (blue) fixing the Disk Board to be removed.
(b) Hold the screws (blue) and pull out and remove the Disk Board.
(c) Insert the dummy into the slot to the end from which the Disk Board (DKB) has been removed.
Figure 11-8 Removing the Disk Board
Disk Board
Screw (blue)
DKC
Shield Finger
Dummy
(d) Remove the other Disk Boards in the same way.
Rev.2
INST(RM)11-04-100
To Next Page
Loading...
