Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)03-02-20]
Rev.1
INST(RM)03-02-20
(2) Installing dummy (Drive)
NOTICE: Do not subject the drive to strong vibrations or shocks during handling due to the
precision part.
(a) Install the dummy (Drive) in the slot from which the Drive has been removed.
NOTE : Be sure to insert the dummy (Drive) in the free slot because it is necessary to regulate
a cooling air flow inside the Storage System.
(b) Insert it into the slot slowly so that the latch part of the dummy (Drive) comes to the lower
side.
Figure 3-6 Installing the Dummy (Drive) (SBX/NBX)
SBX/NBX
Latch
Dummy (Drive)
To Next Page
Loading...
