Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)03-02-30]
Rev.1
INST(RM)03-02-30
2. Removing Drives for UBX
(1) Detaching the Drive
NOTICE: Since the HDD is a precision component, handle it very carefully not to apply a
vibration or shock to it.
NOTE : When handling the Drive, hold the RAIL side because the SHIELD SPRING is
subject to breakage.
Pull the stopper of the handle toward you to have the lock off, and then remove the Drive by
pulling it out taking care not to apply a shock to it.
When using the removed Drive for the purpose of addition to another Storage System, keep it in
custody with its handle returned to its original state (locked by the stopper) taking care not to apply
a shock to it.
Figure 3-7 Removing the Drive (UBX)
Handle
UBX
Stopper
Drive
Drive
SHIELD SPRING
Rail
Safekeeping box
Address label
To Next Page
Loading...
