Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)03-02-40]
Rev.0
INST(RM)03-02-40
(2) Installing dummy (Drive)
(a) Install the dummy (Drive) in the slot from which the Drive has been removed.
NOTE : Be sure to insert the dummy (Drive) in the free slot because it is necessary to regulate
a cooling air flow inside the Storage System.
(b) Insert it into the slot slowly so that the latch part of the dummy (Drive) comes to the left side.
Figure 3-8 Installing the Dummy (Drive) (UBX)
UBX
Latch
Dummy (Drive)
To Next Page
Loading...
