Hitachi DKC910I - Page 43

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)04-03-110]
Rev.2
INST(RM)04-03-110
11. Removing the bezel fixing parts
(1) Procedure for SBX/UBX/NBX
(a) Hold the bottom of the left side bezel (L) on the front side of the Drive Box while opening
outward (

), and then pull and remove (

,

) the bottom of the left side bezel (L) by pulling
it toward you.
Figure 4-8 Removing Side Bezel (L)
(b) Hold the bottom of the right side bezel (R) on the front side of the Drive Box while opening
outward (

), and then pull and remove (

,

) the bottom of the right side bezel (R) by
pulling it toward you.
(c) Remove the side bezels from the other Drive Boxes in the same way.
Figure 4-9 Removing Side Bezel (R)
Side Bezel(L)
Side Bezel(R)