Hitachi DKC910I - Page 54

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)04-03-220]
Rev.2
INST(RM)04-03-220
(2) Procedure for FBX
(a) Remove the screw and the loop cable tie from the rear side of rail.
(b) Loosen the four screws on the rail.
(c) Open the clips on the rail and remove them.
(d) Remove the positioning pins on the rail from the rack and remove the rail.
(e) Remove the other rail in the similar procedure.
Figure 4-21 Removing Slide Rails
Rack frame (Front view)
Screw
Rack frame (Rear view)
Clip
Clip
1 Unit
1 Unit
1 Unit
1 Unit
Positioning pin
Positioning pin
Positioning pin
Rail
Screw
Loop cable tie