Hitachi DKC910I - Page 55

Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)04-03-230]
Rev.2
INST(RM)04-03-230
(3) Procedure for NBX
(a) Remove the screw from the rear side of the rail.
Figure 4-22 Removing Screws
(b) Open the two clips on the front and rear sides of the rail.
(c) Remove the four positioning pins fixing the rail from the front and rear sides of the rail.
(d) Remove the rail.
(e) Remove the other rails in the same manner.
Figure 4-23 Removing Slide Rails
Frame (Rear)
Screw
Frame (Front)
Rail
Rail
Frame (Rear)
Frame (Front)
Positioning pin
Positioning pin
Clip
Clip