Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)06-01-60]
Rev.0.5
INST(RM)06-01-60
(2) Removing Disk Boards.
NOTICE: When removing the Disk Board, hold it with both hands and remove it straight not to
apply a shock to with any components.
Disk Board
Main edge connector
(a) Loosen two screws (blue) fixing the Disk Board to be removed.
(b) Hold the screws (blue) and pull out and remove the Disk Board.
(c) Insert the dummy into the slot to the end from which the Disk Board (DKB) has been removed.
Figure 6-1 Removing Disk Boards
(3) After completing the work of both DKCs, go to Step 7.
Disk Board
Screw (blue)
Shield Finger
DKC
To Next Page
Loading...
