Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)08-01-200]
(c) Removing and routing the LAN cables
Routing before change
(SSVP1 is installed)
Routing after change
(SSVP1 is not installed)
VSP 5100
and
VSP 5100H
HSNBX-0
HSNBX-1
DKC-0
DKC-1
④
①
②
③
HSNBX-0
HSNBX-1
DKC-0
DKC-1
③
VSP 5500
and
VSP 5500H
HSNBX-0
HSNBX-1
DKC-0
DKC-1
⑤
①
②
③
④
HSNBX-0
HSNBX-1
DKC-0
DKC-1
For VSP 5100 and VSP 5100H
(i) Remove the LAN cable between the LAN port (U0) on SSVP0 and the LAN port (U0) on
SSVP1. ( ① )
(ii) Remove the LAN cable between the LAN port (U2) on SSVP0 and the LAN port (U2) on
SSVP1. ( ② )
(iii) Remove the LAN cable from the LAN port (U3) on SSVP1, and then connect to the LAN
port (U3) on SSVP0. ( ③ )
(see (INST(IN)09-03-80))
(iv) Remove the LAN cable kit (one kit) from the HSNBX-1. ( ④ )
Rev.3
INST(RM)08-01-200
To Next Page
Loading...
