Hitachi E1090 - Page 20

Protocol IP addressing method to be used for
configuring the storage system.
MAC Address Read-only field that shows the MAC
address for controllers 1 and 2.
IPv4 Configuration/ IPv6 Configuration ■ IPv4 Address: IPv4 address of the
production network to which the
storage system will be connected
(IPv4 only).
■ IPv6 Address: IPv6 address of the
production network to which the
storage system will be connected
(IPv6 only).
■ Subnet Mask: IP address mask that
identifies the range of IP addresses in
the subnet to which the storage
system will be connected.
■ Subnet Prefix Length: Subnet prefix
length of the network to which the
storage system will be connected
(IPv6 only).
■ Default Gateway: IP address of the
default gateway to which the storage
system will be connected. The
gateway is the IP address of the router
used to communicate outside the local
subnet.
■ DNS Server 1-3: If your configuration
uses DNS to resolve IP addresses (for
example, the IP address for the NTP
server used with the storage system),
enter up to three DNS IP addresses.
Network Connection Mode Determines whether the storage system
negotiates the speed and duplex mode
automatically with the attached device.
The default setting (Auto-Negotiation)
connects the storage system at the
highest speed and appropriate duplex
setting supported by itself and the
connected device.
Running the Initial Setup wizard
Installing your storage system
Hitachi Virtual Storage Platform E1090 Installation Guide 20