Option ■ DNS Domain Name: IP address of the
DNS server that will perform address
resolution.
■ DNS Search Order: Search domain
names. Use the Up and Down buttons
to order the domain names.
■ Maintenance Port: Do not change
these values.
■ Internal Network: Do not change this
value.
4. Click Apply, and then click Close.
The system logs you out.
5. Remove the Ethernet cable from the management console and attach the cable to your
production network. Leave the other end of the cable connected to the management
port on the rear of the controller.
6. Connect one end of another Ethernet cable to the management port on the rear of the
other controller. Connect the other end of the cable to your production network.
7. Wait 5 minutes for the maintenance utility to fetch the new IP addresses.
8. Open a web browser, and log in to Storage Advisor Embedded again. Use the new IP
address you specified in the Initial Setup wizard and the new password you specified
for the maintenance user.
9. In the top-right corner, click the gear icon, and then select User Administration.
10. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
11. Enter the system information, and then click Apply and Next.
Running the Initial Setup wizard
Installing your storage system
Hitachi Virtual Storage Platform E1090 Installation Guide 21
To Next Page
Loading...
