Hitachi E590 - Page 16

Option ■ DNS Domain Name: IP address of
the DNS server that will perform
address resolution.
■ DNS Search Order: Search domain
names. Use the Up and Down
buttons to order the domain names.
■ Maintenance Port: Do not change
these values.
■ Internal Network: Do not change
this value.
4. Click Apply, and then click Close.
The system logs you out.
5. Remove the Ethernet cable from the management console and attach the cable to
your production network. Leave the other end of the cable connected to the
management port on the rear of the controller.
6. Connect one end of another Ethernet cable to the management port on the rear of
the other controller. Connect the other end of the cable to your production
network.
7. Wait 5 minutes for the maintenance utility to fetch the new IP addresses.
8. Open a web browser, and log in to Storage Advisor Embedded again. Use the new IP
address you specied in the Initial Setup wizard and the new password you
specied for the maintenance user.
9. In the top-right corner, click the gear icon, and then select User Administration.
10. In the maintenance utility navigation tree, under Menu, click Initial Setup Wizard.
11. Enter the system information, and then click Apply and Next.
Running the Initial Setup wizard
Installing your VSP E590 and VSP E790 storage system
Hitachi Virtual Storage System E590, E790 Installation Guide 16