Before you begin
Make sure the storage system is connected to your production network.
Procedure
1. Using the appropriate cable, connect the iSCSI data ports on each storage system
controller to your Gigabit Ethernet network switch.
2. Connect your Gigabit Ethernet network switch to the NIC or HBA card in each host
computer or server.
Step 8: Register your storage system with Hitachi Vantara
Support
If you do not already have an account on the Support Website, you will need to register.
Otherwise, you will not be able to download and install the Hitachi Remote Ops
monitoring system, and you will encounter delays in getting your storage system running
and supported.
Before you begin
■
Register an account on the Support Website.
Procedure
1. Locate the product serial number (labeled MFG. NO.) on the rear of the controller.
You will need this number to register your storage system.
2. Open a web browser on your PC or mobile device.
3. Log in to the Support Website, and follow the instructions to register your storage
system. If you have previously registered Hitachi Vantara products, you can add an
additional site.
Step 9: Install Hitachi Remote Ops monitoring system
Hitachi Remote Ops monitoring system monitors your storage system and noties
Hitachi Vantara when assistance is required. Hitachi Remote Ops runs on Windows,
Linux, and Solaris operating systems.
Step 8: Register your storage system with Hitachi Vantara Support
Installing your VSP E590 and VSP E790 storage system
Hitachi Virtual Storage System E590, E790 Installation Guide 22
To Next Page
Loading...
