Number Item
1 Pin
2 Clip
3 Washer and bind screw
4. Position the controller so the front faces the front of the rack, and then slide the
controller gently onto the rails. Stop sliding when the mounting anges on the front
of the controller touch the vertical face of the rack.
Note: Check the rear of the controller chassis to be sure the chassis is t
into the stoppers.
Number Item
1 Stopper
5. On the front of the controller chassis, attach the two bind screws and washers to
each side of the rack.
Step 2: Install the storage system into a rack
Installing your VSP E590 and VSP E790 storage system
Hitachi Virtual Storage System E590, E790 Installation Guide 6
To Next Page
Loading...
