Item Name Color Description
5 ENC OUT LED Green ON - Indicates that the port is connected to an IN port in the controller.
This can be directly or indirectly, as described above.
6 Console port - RJ-45 connector (not used)
7 Power Supply - Converts 200 VAC to the DC voltages used by the drives and the ENC
adapters.
8 RDY (Ready) LED Green OFF - No power is supplied to the system or the power supply has failed.
ON - The power supply is operating normally.
9 AC IN LED Green ON - AC input is normal.
10 ALM (Alarm) LED Red Power supply has failed. Contact technical support. See Getting Help in the
preface of this manual.
11 AC Socket - For IEC60320-C14 plug, 200 - 240 VAC +8% - 6% 50/60 Hz
Figure 9 FMD drive tray
Item
Description
1 Flash module Active LED - Lights when the flash module is activated- Blinks at drive
access.
2 Flash module Alarm LED - Lights when the flash module has an error and should be
replaced.
3 SAS / ENC Module Power LED
4 SAS / ENC Module Alarm LED - Indicates fatal error condition.
5 SAS / ENC standard IN connector
6 SAS / ENC high performance IN connector
7 ENC adapter - Connects the flash modules to the BEDs in the controller via ENC cables.
8 SAS / ENC standard OUT connector
42 Introduction
Hitachi Virtual Storage Platform G1000, G1500, and Virtual Storage Platform F1500 Hardware Guide
To Next Page
Loading...
