Travelstar 5K160 (SATA) Hard Disk Drive Specification
80/167
14.6 Format Track (50h: Vendor Specific)
Command Block Output Registers Command Block Input Registers
Register 7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0
Data - - - - - - - - Data - - - - - - - -
Feature - - - - - - - - Error ...See Below...
Sector Count - - - - - - - - Sector Count - - - - - - - -
LBA Low V V V V V V V V LBA Low V V V V V V V V
LBA Mid V V V V V V V V LBA Mid V V V V V V V V
LBA High V V V V V V V V LBA High V V V V V V V V
Device - L - - H H H H Device - - - - H H H H
Command 0 1 0 1 0 0 0 0 Status ...See Below...
Error Register Status Register
7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0
CRC UNC 0 IDN 0 ABT T0N AM
N
BSY RDY DF DSC DRQ COR IDX ERR
0 0 0 V 0 V 0 0 0 V 0 V - 0 0 V
Figure 31 Format Track Command (50h)
The Format Track command formats a single logical track on the device. Each good sector of data on
the track will be initialized to zero with write operation. At this time, whether the sector of data is
initialized correctly is not verified with read operation. Any data previously stored on the track will
be lost.
Output Parameters To The Device
LBA Low
In LBA mode, this register specifies LBA address bits 0 - 7 to be formatted. (L=1)
LBA High/Mid
The cylinder number of the track to be formatted. (L=0)
In LBA mode, this register specifies LBA address bits 8 - 15 (Mid), 16 - 23 (High) to be
formatted. (L=1)
H
The head number of the track to be formatted. (L=0)
In LBA mode, this register specifies LBA address bits 24 - 27 to be formatted. (L=1)
Input Parameters From The Device
LBA Low
In LBA mode, this register specifies current LBA address bits 0-7. (L=1)
LBA High/Mid
In LBA mode, this register specifies current LBA address bits 8 - 15 (Mid), 16 - 23 (High)
H
In LBA mode, this register specifies current LBA address bits 24 - 27. (L=1)
In LBA mode, this command formats a single logical track including the specified LBA.
To Next Page
Loading...
