EasyManua.ls Logo

Hitachi HTS541616J9SA00 - 14.8 Identify Device (ECh)

Hitachi HTS541616J9SA00
167 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Travelstar 5K160 (SATA) Hard Disk Drive Specification
82/167
14.8 Identify Device (ECh)
Command Block Output Registers Command Block Input Registers
Register 7 6 5 4 3 2 1 0 Register 7 6 5 4 3 2 1 0
Data - - - - - - - - Data - - - - - - - -
Feature - - - - - - - - Error ...See Below...
Sector Count - - - - - - - - Sector Count - - - - - - - -
LBA Low - - - - - - - - LBA Low - - - - - - - -
LBA Mid - - - - - - - - LBA Mid - - - - - - - -
LBA High - - - - - - - - LBA High - - - - - - - -
Device - - - - - - - - Device - - - - - - - -
Command 1 1 1 0 1 1 0 0 Status ...See Below...
Error Register Status Register
7 6 5 4 3 2 1 0 7 6 5 4 3 2 1 0
CRC UNC 0 IDN 0 ABT T0N AM
N
BSY RDY DF DSC DRQ COR IDX ERR
0 0 0 0 0 V 0 0 0 V 0 - - 0 0 V
Figure 33 Identify Device Command (ECh)
The Identify Device command requests the device to transfer configuration information to the host.
The device will transfer a sector to the host containing the information in “Identify device
information” on Page 5-5.
Word Content Description
00 045xH Drive classification, bit assignments:
15 (=0): 1=ATAPI device, 0=ATA device
* 14 (=0): 1=format speed tolerance gap required
* 13 (=0): 1=track offset option available
* 12 (=0): 1=data strobe offset option available
* 11 (=0): 1=rotational speed tolerance > 0.5%
* 10 (=1): 1=disk transfer rate > 10 Mbps
* 9 (=0): 1=disk transfer rate > 5 Mbps but <= 10 Mbps
* 8 (=0): 1=disk transfer rate <= 5 Mbps
7 (=0): 1=removable cartridge device
6 (=1): 1=fixed device
* 5 (=0): 1=spindle motor control option implemented
* 4 (=1): 1=head switch time > 15 us
* 3 (=1): 1=not MFM encoded
2 (=x): 1=Identify data incomplete
* 1 (=1): 1=hard sectored
0 (=0): Reserved
01 Note.2 Number of cylinders in default translate mode
02 xxxxh Specific configuration
C837h SET FEATURES subcommand is not required to spin-up
and IDENTIFY DEVICE response is complete
37C8h SET FEATURES subcommand is required to spin-up and
IDENTIFY DEVICE response is incomplete
03 Note.2 Number of heads in default translate mode
04-05 0 * Reserved
06 003FH Number of sectors per track in default translate mode
07-09 0 Reserved

Table of Contents

Related product manuals