Hitachi IJ RX2-BD160 - 9.1 Display when warning or fault was generated; (2) When warning was generated; (3) When a mistake was generated or when processing judgment is prompted

9-2 ●Display when warning or fault was generated
◇◇◇◇◇ Ink Low Warning ◇◇◇◇◇081
The ink level in the ink reservoir is low.
Cause 1. The ink reservoir is almost empty.
2. The Low Level sensor in the ink reservoir is faulty.
Solution 1. Add more ink to the ink reservoir within 60 minutes.
2. Check the Low Level sensor.
Close
===== Ink Jet Startup Confirmation =====186
The ink jet will be turned ON.
Solution To turn the ink jet ON, press <Ready>.
Close
Ready
●When Close is pressed, the warning window is closed, but the warning state is not cleared.
The warning name is displayed in the warning display area (see the figure above).
●If the warning state is cleared, the warning display is automatically closed.
(2) When warning was generated
(3) When a mistake was generated or when processing judgment is prompted
●The contents of the confirmation message are described at the place of each operation.
Message No.
The name of the warning
message is displayed.
The description, cause,
and solution are displayed.
Message No.
The name of the confirmation
message is displayed.
The description, cause,
and solution are displayed.