9-8 ●On-screen message descriptions
No. Message Meaning of message Remedy
80
Excitation V-ref.
Review 2
Up date the excitation voltage reference.
Print quality may become poor.
● Perform nozzle test and
update the excitation V-ref.
setting.
( Technical manual 6.11)
● Watch for the print results and
the Excitation V-ref.
Setting. for about 2 hours
after operation is started.
81 Ink Low Warning The ink level in the ink reservoir is low.
● Add ink within 60 minutes
( 8.1).
82
Makeup Low
Warning
The makeup level in the makeup reservoir
is low.
● Add the makeup within 60
minutes.
( 8.2).
83
Ink Shelf Life
Expired
Ink replacement time has come.
● Replace the ink
( Technical manual 6.3).
84
Ambient
Temperature Too
High
The ambient temperature is above the
proper level.
● Ensure that the ambient
temperature is within the
operating temperature limits.
85
Ambient
Temperature Too
Low
The ambient temperature is below the
proper level.
● Ensure that the ambient tem-
perature is within the operat-
ing temperature limits.
87 Ink Pressure High
Ink pressure is higher than the
recommended value.
● Adjust the pressure-reducing
valve to correct the pressure.
88 Battery Low C
The internal battery in controller section is
low.
● Contact your nearest local
distributor.
● Replace the internal battery
in engine section and set the
data/time. ( 6.2).
93 Ink Pressure Low
Ink pressure is lower than the
recommended value..
● Adjust the pressure-reducing
valve to correct the pressure.
95
Product Speed
Matching Error
The encoder pulse rate exceeds the
available printing speed.
● Slow the print target speed.
● Decrease N in the ink drop
use percentage (1/N).
( 4.14.1).
129 Model-key Failure Model-key recognition failed.
● Contact your nearest local
distributor.
130
Language-key
Failure
Language-key recognition failed.
● Contact your nearest local
distributor.
131 Upgrade-key Fault Upgrade-key recognition failed.
● Co
ntact your nearest local
distributor.
135
Circulation System
Cooling Fan
Fault
The cooling fan of the circulation system
area is faulty.
● Contact your nearest local
distributor.
136
Inside Temperature
Too High
The temperature inside the printer is
increasing.
● Prease confirm the ink
recovery status.
● Replace the air filter or make
the space around printer.
● Contact your nearest local
distributor.
To Next Page
Loading...
