Hitachi KHD101E - DAB Operation; Scanning for DAB Stations

DAB Operation
If the unit is connected to the mains power for the rst time, the unit will
show “Welcome to Digital Radio“ and then perform auto scan. During
the scan the display will show “Scanning…” together with a slide bar that
indicates the progress of the scan and the number of stations that have
been found so far.
Once the scan has nished, the unit will broadcast the rst
alphanumerically found station. To explore the found stations, press /
and then Enter button to conrm selection.
Full Scan
The full scan will search for the entire DAB Band III channels. After the scan
has nished, the rst alphanumerically found station will be automatically
broadcast.
Full scan will not replace the DAB stations in memory. If you want to
remove all the previously scanned stations, factory reset is required.
1. To activate full scan, press Menu then / to select <Full scan>.
Press Enter to conrm. The display will show “Scanning…” and a
progressing slide bar.
2. All the stations that have been found will be stored automatically. To
explore and listen to the found stations, press / and then Enter
button to conrm selection.
Manual Tuning
Manual tuning can help add stations that were missed by full scan.
1. Press Menu and then / to select <Manual tune>. Press Enter to
conrm.
2. Press / to scroll through the DAB channels, which are numbered
from 5A to 13F.
3. Press Enter to select the station that you would like to listen to.
20
GB