Need help?Do you have a question about the Hitachi L2002 Series and is the answer not in the manual?
Summarizes UL guidelines and electrical practices for inverter installation safety.
Specifies terminal tightening torque and appropriate wire sizes for connections.
Details recommended fuse and circuit breaker ratings for input power wiring.
Illustrates power and control circuit terminal layouts and connections for various models.
Provides a diagram showing power and motor connections for basic inverter operation.
Explains the inverter's solid-state motor overload protection and its parameter settings.
Details the inverter keypad layout, button functions, and navigation map for operation.
Outlines a test procedure using minimal settings to verify inverter and motor operation.
Lists and explains error codes, their causes, and how to view trip conditions.
Provides instructions for resetting the inverter to its original factory default settings.
Details parameters for monitoring inverter status like frequency, current, and terminal states.
Lists primary configuration parameters for output frequency, acceleration, and deceleration.
Lists parameters for standard functions like frequency source and run command source selection.
Details parameters for fine-tuning inverter behavior, including restart modes and thermal settings.
Lists parameters for configuring intelligent input/output terminals and alarm relay functions.
Provides listings for intelligent output terminals, analog input, and analog output functions.
To Next Page
General