Hitachi NAS Platform 4040 - Installing the New Node; Finalizing and Verifying the Server Configuration

Installing the new node
You are now ready to install the new node.
Procedure
1. Physically rack the new node into the place of the old node.
2. Connect the cables to the new node, according your labelling.
3. Power up the new node and ensure that BALI loads again.
4. If the customer is using SAN attached, and/or host group security, update this to
reect the changes that are being made to the WWN, as you documented previously
in Pr
eparing the node, step 5.
5. Add the ne
w node as a managed server on the SMU.
6. From the drop down in the SMU, select the existing Cluster.
7. Go into Home > Sever Settings > Cluster Conguration and click on AddCluster
node.
8. Complete the add cluster node wizard, selecting the new node which will appear
in the selection box, and enter the supervisor password where prompted (the
default is supervisor). Upon completion of the wizard, the new node will reboot
and join the cluster.
Finalizing and verifying the server configuration
On the new server:
Procedure
1. Navigate to Home > Status & Monitoring > System Monitor to verify the server
status:
Installing the new node
Appendix A: Server replacement procedures
Hitachi NAS Platform and Hitachi Unied Storage Series 4000 Hardware Reference 112