30
PJ-TX100(C11H)
Wiring diagram 2 (C11H)
Power block wiring (for circuit board block SUB ASS’Y assembly)
Attachment of ballast power block
(1) Wire and connect CNPWR.
(2) Wire CN1 and CD2.
(3) Wire TSW and CNPOW. Attach FEB3.
CNPWR
Lamp
lead
CN1
Pass CN1 and CD2 through slit in
circuit power case sheet.
Connect and lock CNPWR connector
to ballast power CN1.
Arrange lead as shown.
Do not allow FEB2 to contact ballast
circuit board.
After attachment of ballast power block
(1) Secure FEB3.
CNPOW
Assembly procedure
(1) Pass CN1 and CD2 through slit in insulation sheet of
circuit board power block.
(2) Connect one end of CNPWR to ballast power.
(3) When attaching ballast power block to circuit power block,
pass TSW and CNPOW through ballast power block fastener.
Lock fastener.
CNBAR
Pass TSW and CNPOW through
ballast power case fastener and
lock fastener.
FEB2
CD2
TSW
TSW
CNPOW
FEB3
Pass binding bands through holes on top of ballast
power case (shown below with dotted lines) and
secure FEB3.
Cut excess length from binding bands.
Z3
FEB3
Attach FEB3 (ferrite core)
to CNPOW and TSW.
Do not snag lead.
To Next Page
Loading...
