29
PJ-TX100(C11H)
7. Wiring diagram
Wiring diagram 1 (C11H)
CNPOW
CNPWR
Circuit/Ballast power circuit board wiring
Circuit power circuit board wiring
(1) Connect TSW.
(2) Connect CNPOW.
(3) Connect CNPWR and FEB2.
(4) Connect CN1, CD2, and FEB1.
CN102
CN103
CN3
CN101
Ballast power circuit board wiring
(1) Connect CNBAR.
(2) Wire lamp lead and CNBAR.
TSW
C104
T201
Connect and lock CNPWR
connector to CN101
completely.
Do not insert incorrectly –
Circuit power system is 4P;
Ballast power system is 3P.
Confirm CN102 and CN103
are correctly connected
(as they cannot be accessed later).
Confirm CNBAR is correctly connected
(as it cannot be accessed later).
CN1
Connect and lock connector
CN1 completely.
FEB2
FEB1
Attach FEB2 (ferrite core)
to CNPWR close to circuit
board.
Attach FEB1 (ferrite core) to
CN1 and CD2.
CD2
T101
CN2
CNBAR
CN1
T1
Pass lamp lead and
CNBAR through slit in
insulation sheet.
Lamp
lead
To Next Page
Loading...
