33
PJ-TX100(C11H)
Wiring diagram 5 (C11H)
P601
P701
P501
E805
EW01
E802
E301
E7A1
E301
E806
E804
E801
E800
Main circuit board mounting wiring
(1) Connect CNPOW. Exercise caution when accessing back of circuit board.
(2) Connect CNSH, CNBAR, exhaust fan, sub fan, internal air sensor, iris, CNRM,
panel fan, external air sensor, and CNME.
(3) Connect flexible cable for liquid crystal panel.
CNBAR
WOPNC
CNSH
Pass CNSH lead between main
circuit board and optical engine.
CNRM
Pass CNRM and iris leads through
fasteners on side of lens shift (to prevent
snagging by upper case, contact with
legs and lens shift moving parts).
Secure CNSH with screw as shown below.
CNSH
Approx. 90°
Rear of set
Main circuit
board
Shield
I/O metal
Attach flexible cable as shown below.
Flexible cable
Connector Base
Fit flexible cable securely into connector base.
Insert with correct surface up as connector
contacts on top surface only.
Move the lock hinge in the direction of the
arrow and lock securely.
Pass external air sensor
and panel fan leads
through hook on top of
intake upper. Pull toward
rear of set and remove
slack (to prevent snagging
by upper case).
Pass CNME lead through hook on
top of intake upper. Pull towards
LED circuit board and remove slack
(to prevent snagging by upper case).
CNME
Pull CNBAR lead towards
drive circuit board.
Position iris
lead in groove
on top of lens
shift and then
wire CNRM
lead.
After wiring external air temperature sensor
and panel fan leads, wire internal air
temperature sensor as shown.
External
air sensor
Panel fan
Iris
Sub fan
Internal
air sensor
Exhaust
fan
To Next Page
Loading...
