4 Individual remote controls
Receiver kit for wireless remote control
TCGB0106 rev.0 - 12/2014
205
4
Installation procedure
CAUTION
Follow these installation procedures carefully. Failure to do so may cause the receiver to become detached from the panel causing a
serious accident.
1 Install the wireless receiver kit and indoor unit at the same time.
2 If installing the wireless receiver kit after the indoor unit, unplug the power source from the indoor unit.
3 Make sure the distance between the wireless receiver kit and indoor unit is less than 5 metres.
4 Remove the cover using a at-head screwdriver.
5 Install the wireless receiver kit on the wall or ceiling, as shown below:
In cases where the remote control cable is exposed
a. Mount the wireless receiver kit xing bracket with the screws (A) at
the 4 positions.
Screw (A)
b. Cut one of the pre-drilled holes (*) on the cover.
c. Run the cable through the groove and pull it out through the pre-
drilled hole.
d. Fit the cover, making sure not to snag the cable.
Cover
Click sound
Fixing bracket
Hook
To Next Page
Loading...
