7 Gateways for building management systems
KNX001
TCGB0106 rev.0 - 12/2014
646646
7.3 KNX001
7.3.1 Safety summary
CAUTION
• This interface KNX001 must be installed by skilled personal (electrician, EIB installer or other skilled technician).
• Do not connect voltage input to the control system before installation has been correctly completed.
• This appliance must be used only by adult and capable people, having received the technical information or instructions to handle
properly and safely this appliance.
• Children should be supervised to ensure that they do not play with the appliance.
• Install KNX001 away from possible sources of electromagnetic waves.
• Respect local electrical standards.
• Use a power circuit that is not subject to peak demands.
• Ensure that there is enough free space around the KNX001 so that the heat may dissipate adequately
(refer to “Installation Work”).
• If you install the KNX001 in vertical position, install the power supply in the lower part and the temperature control outputs in the
upper part.
Do not install KNX001 in places... :
• outdoor.
• with vapour, oil or dispersed liquids.
• exposed to sun radiation.
• with heat sources nearby (sulphuric surroundings).
• where accumulation, generation or leaks of inammable gases has been detected.
• that are near the sea, in saline, acid or alkaline surroundings.
• with wet environment.
NOTE:
• Read this manual carefully before performing installation and conguration works.
• For additional information concerning programming and software operation, please refer to the CSNET WEB information.
To Next Page
Loading...
