Hitachi PSC-6RAD - Page 301

Information
Restore setting can be set by the screen of “Start-up” displayed.
1 Tap “Restore Setting” for more than 5 seconds in the lower right on the screen of “Start-up”.
2 After a while, connection check process is started.
3 When the process for connection check is nished, “Adjusting Date/Time” screen is indicated. (Refer to Adjusting
Date/Time)
Start-up
Restore Setting
Press and hold “Restore” button for at least 5 seconds.
Restore
Restore Setting

Checking Connection
1 Select “Checking Connection” on the screen of “Service Menu”.
NOTE
This function cannot be selected when the air conditioner(s) is operated or the external input signal is input to the external input terminal
1 or 2.
2 Tap “OK” at the conrmation screen.
NOTE
If tap “Cancel”, the screen will be returned to “Service Menu”. Proceed to update the connection information depending on the setting
afterwards.
• Update connection information with keeping Group register and settings such as schedule setting, etc. (3)
• Perform reconnection checking by initializing each setting. (It is same as the restore setting). (7)
Back
Service Menu
25/01/2010 (Mon) 10:20
Group Register
Optional Function
Setting
Exception Setting
of Run/Stop
Operation
External
Input/Output Setting
Exception
External Input
Demand Function
Setting
Button Setting
Alarm History
Checking
Connection
Restore Setting
Contact Info.
Register
(1)
CancelOK
Confirmation
Start checking connection?
(2)
5 Centralised remote controls
PSC-A64GT
TCGB0106 rev.0 - 12/2014
285
5