– 24 –
ATTACHING THE AIR CLEANSING AND DEODORIZING FILTERS
Before installation, be sure to stop the operation by using the remote controller.
1
Open the front panel.
● Pull up the front panel holding it at both sides by both
hands.
2
Remove the filter.
● Push the filter upward to release the claws
and pull out the filter.
3
Attaching the air cleansing and deodorizing filters to
the filter.
● Attach the air cleansing and deodorizing filters to the
frame by gently compress its both sides and release
after insertion into filter frame.
NOTE
● In case of removing the air cleansing and deodorizing filters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air cleansing
and deodorizing filters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air cleansing and deodorizing filters are washable and reusable up to 20 times by using vacuum cleaner
or water rinse under running tap water. Type number for this air cleansing filter is <SPX-CFH5>.
● Do not operate the air conditioner without filter. Dust may enter the air conditioner and fault may occur.
4
Attach the filter.
● Attach the filter by ensuring that the surface written
“FRONT” is facing front.
● After attaching the filter, push the front panel at three
arrow portions as shown in figure and close it.
Claws (8 places)
Make sure the “FRONT” is facing back side
Claws
Front cover
Front panel
Air filter
!
CAUTION
Do not bend the air cleansing
and deodorizing filter as it may
cause damage to the structure.
Frame
To Next Page
Loading...
