– 31 –
– 46 –
• Filter may not be cleaned evenly depending on the environment in which the air
conditioner is used. To solve this problem, clean the micro mesh stainless filter.
• Depending on dust amount, the micro mesh stainless filter may not be completely
cleaned by manual filter cleaning operation performed at your preferred time while
filter cleaning operation is prohibited.
TROUBLESHOOTING (continued)
FILTER CLEANING OPERATION (continued)
Micro mesh
stainless filter is
still dirty
ANTI-MOLD WASABI CASSETTE
• Anti-mold elements with wasabi aroma prevents mold growth inside the dust box in which the dust collected
by filter cleaning operation is kept. Although only a trace amount of anti-mold elements is released, there may
be wasabi smell in the room depending on the environment in which the air conditioner is used. If you feel this
smell is unpleasant, block one of the anti-mold element outlets with a commercially available adhesive tape. If
this measure is taken, the amount of anti-mold element to be released will be reduced and the anti-mold effect
will also be less accordingly. To prevent mold growth, frequent cleaning of the dust box is recommended.
Anti-mold wasabi cassette
Outlet (2 places)
The gap made on
the side surface
Block one of the outlets with an
adhesive tape
(Either one of 2 outlets)
– 47 –
ENGLISH
• Do the batteries need replacement?
• Is the polarity of the inserted batteries correct?
• Is the power plug inserted properly?
• Is the fuse blown out or circuit breaker tripped?
• Is there a blackout? (Operation remains idle after a blackout.)
• Is the micro mesh stainless filter blocked with dust?
• Is the set temperature suitable?
• Have the vertical air deflector been adjusted to the correct positions according to
the operation mode selected?
• Are the air inlets and air outlets of indoor and outdoor units blocked?
• Is the fan speed “LOW” or “SILENT”?
• Is the front panel closed properly?
• Is the front panel closed properly?
• Check “filter cleaning operation”.
• Is the front panel closed properly?
PLEASE CHECK THE FOLLOWING BEFORE SERVICE
Signal cannot be
received
(Remote controller
display is dim or
blank)
Operation does
not start
Does not cool well
Does not heat well
Movable panel does
not move
(CLEAN)
indicator blinks
(CLEAN)
indicator blinks
after cooling,
dehumidifying and
dry cool operations
FAILURE OF IONIZED MIST GENERATOR AND ELECTRIC DUST COLLECTOR
• If the (MIST/AIR PURIFYING) indicator on the indoor unit is continuously blinking, check the dirt on
the ionized mist generator and electric dust collector. Clean them if they are dirty. (Page 42)
If the
(MIST/AIR PURIFYING) indicator still continues to blink, the ionized mist generator and/or electric
dust collector is out of order.
In this case, ionized mist operation and stainless plasma air purifying operations are unavailable,
however other functions of the air conditioner are available without being affected.
• Contact your sales agent if the Ionized Mist generator and electric dust collector malfunctions.
To Next Page
Loading...
