EasyManua.ls Logo

Hitachi RCIM-1.5FSRE - Page 149

Hitachi RCIM-1.5FSRE
314 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5 Optional functions
Optional functions through Remote control
SMGB0137 rev.0 - 05/2021
139
5
PA – Daylight saving time
This function is used to set the amount of adjustment when daylight saving time is applied.
Pb – Not used
PC – Not used
q1 – Not used
q2 – Not used
q3 – Not used
q4 – Not used
q5 – Not used
q6 – Not used
q7 – Not used
q8 – Not used
q9 – Not used
qA – Not used
qb – Operation mode with setback
This function is used to select the operation modes in which setback operation is activated to keep a minimum comfort in
the room while it is not occupied.
qC – Temperature differential for the setback function
This function is used to select the temperature di󰀨erential for the setback function.
Target temperatures for cooling and heating operation are determined versus a temperature to start setback operation
(rE, rF).
Target temperature calculation:
Target temperature in cooling mode: rF - qC (°C)
Target temperature in heating mode: rE + qC (°C)
HeatingCooling
Run
Stop
Target temp. in setback cooling operation
(rF qC)
Wired Controller setpoint in cooling normal oper
ation
Wired Controller setpoint in heating normal oper
ation
Temp. to start setback operation in heating mod
e (rE)
Target temp. in setback heating operation
(rE qC)
room temperature
Temp. to start setback operation in cooling mod
e (rF)
Temperature to start setback operation in cooling mode
Target temperature in setback cooling operation
Wired controller setpoint in cooling normal operation
Wired controller setpoint in heating normal operation
Target temperature in setback heating operation
Temperature to start setback operation in heating mode
Room temperature
Heating
Cooling
Stop
Run
Setback operation runs as room temperature reaches the specied temperature to start, and stops when the target 
temperature is reached.
A target temperature higher than the normal operation temperature shall be selected for cooling mode.
A target temperature lower than the normal operation temperature shall be selected for heating mode.

Table of Contents

Other manuals for Hitachi RCIM-1.5FSRE

Related product manuals