2-42
SERVICING
(2.2 In-the-Ceiling Type)
(9) Remove two (2) lower M6 screws fixing the motor base and loosen the upper two (2) M6 screws.
(10) Remove four (4) M4 screws fixing the ring of the casing at the rear side of the fan motor and remove
the motor base, the ring and the runner at the
same time.
Phillips ScrewdriverTool
TURN OFF all power source switches.
(11) Loosen the screw fixing the runner onto the fan motor by the adjustable wrench and pull out the
runner.
Phillips Screwdriver, Adjustable WrenchTool
ATTENTION:
The total weight of the motor base, the fan motor, the ring and the runner is approximately 15kg.
Carefully perform the above removing work.
Runner Fixing Screw
M6 Screws
Motor Base
Ring
M4 Screws
Motor Base
Fan Motor
Runner
To Next Page
Loading...
