● Introduction ........................................................... 0-1
● Cautions ................................................................. 0-1
Types of Warnings ................................................ 1-1
Description of Safety Symbols .............................. 1-1
Precautions for Installation ................................. 1-2
Precautions for Wiring ........................................ 1-2
Precautions to Run and Test Running ................. 1-3
Check the Inverter ................................................ 2-1
Install the Inverter ................................................ 2-2
Dimensions ........................................................... 2-5
Inverter Wiring ..................................................... 2-8
Wiring of the main circuit ..................................... 2-9
Recommended wire gauges, accessories etc...... 2-10
Set the load rating ................................................ 3-1
Set the motor data ............................................... 3-1
Frequency setting from keypad ............................ 3-2
Run key using on the keypad ................................ 3-2
Multispeed terminals command .......................... 3-3
Operate using FW/RV terminal ............................. 3-3
Keypad overview .................................................. 4-1
Monitor naming .................................................... 4-6
Error events .......................................................... 5-1
Inspection and maintenance notes ...................... 6-1
Daily and periodic inspections .............................. 6-2
Insulation resistance test ...................................... 6-3
Dielectric withstand test ....................................... 6-3
Specifications ........................................................ 7-1
Common specifications ........................................ 7-3
● Index .......................................................... Appendix-1
● Method of Inquiry and Product Warranty .......... 0-2
● Contents ............................................................... 0-4
Precautions for Maintenance/Inspection ................. 1-4
Precautions for disposal ............................................ 1-4
Other Cautions ............................................................ 1-4
Compliance to European Directive (CE) ...................... 1-5
Applicable Circuit Breaker ......................................... 2-11
Chopper Breaking Resistor ........................................ 2-13
Wiring to the main circuit terminal block ................. 2-14
Wiring of the Control Circuit ..................................... 2-17
Control Circuit Wiring Section ................................... 2-19
Residual Risk ............................................................. 2-24
Potentiometer frequency command ........................... 3-4
Operate using 3WIRE terminal .................................... 3-4
Adjust the analog input(Ai1/Ai2) ................................ 3-5
Adjust the analog output(Ao1/Ao2/FM) ..................... 3-5
Adjust the analog input(Ai3) ....................................... 3-6
Input terminal chatter prevention .............................. 3-6
Parameters naming ..................................................... 4-9
Possible errors and solutions ........................................ 5-4
Checking method for inverter/converter .................... 6-4
Smoothing capacitor lifespan curve ............................ 6-5
Lifespan alarm output ................................................. 6-5
Input/output voltage, current ..................................... 6-6
Current derating ............................................................ 7-5
To Next Page
Loading...
