Chapter 2 Installation and Wiring
2 - 10
(3) Explanation of switch
SW1: It is a switch that switches effective and the invalidity of the urgent disconnect function (The
state of the factory shipment: this function invalidity).
Please use the urgent invalidity function after perusing "4.4 urgent disconnect function".
Note: Slide Switch SW12
Some models have slide switch in the position as shown below. Default setting of this switch is at "ON" position.
Please don't change the setting. If it is changed, inverter may trip and disabled to run.
ＯＮ
Slide switch SW1
OFF ON
Slide lever (factory setting: OFF)
Logic board
ON
OFF
ON
Slide lever
(factory setting: ON)
Slide switch SW12
To Next Page
Loading...
