Hitachi Virtual Storage Platform G130 - Page 15

Input power specifications
CBSS/CBSL controller
chassis DBS/DBL drive tray
(VA/W) DBL: 280/260 or less
Note:
1. The power current of N2 described in this table is required for operation by a
single power supply unit.
2. If one power supply unit fails, another power supply unit requires electric current
for the two power supply units. Therefore, plan the power supply facility so the
current carrying capacity of one power supply unit can provide a total capacity of
the two power supply units.
3. Power requirement for the maximum conguration is shown. Value at 100 V/200
V is shown. The actual required power may exceed the value shown in the table
when the tolerance is included.
Environmental specications
The following table describes the environmental specications for the VSP G130.
Note: The VSP G130 storage system components are not supported in high-
temperature environments. Do not operate the Hitachi Vantara-provided
service processor (SVP) at temperatures of 40°C or higher.
Technical specications
Chapter 2: Hardware components and specications
Hitachi Virtual Storage Platform G130 Hardware Reference Guide 15